Infrared Ellipsometry - a Novel Tool for Characterization of Group-III Nitride Heterostructures for Optoelectronic Device Applications

2001 ◽  
Vol 228 (2) ◽  
pp. 437-440 ◽  
Author(s):  
M. Schubert ◽  
A. Kasic ◽  
S. Einfeldt ◽  
D. Hommel ◽  
U. K�hler ◽  
...  
1998 ◽  
Vol 189-190 ◽  
pp. 435-438 ◽  
Author(s):  
Hiroshi Harima ◽  
Toshiaki Inoue ◽  
Shin-ichi Nakashima ◽  
Hajime Okumura ◽  
Yuuki Ishida ◽  
...  

Author(s):  
M. Schubert ◽  
A. Kasic ◽  
T.E. Tiwald ◽  
J. Off ◽  
B. Kuhn ◽  
...  

We report on the application of infrared spectroscopic ellipsometry (IR-SE) for wavenumbers from 333cm−1 to 1200cm−1 as a novel approach to non-destructive optical characterization of free-carrier and optical phonon properties of group III-nitride heterostructures. Undoped α-GaN, α-AlN, α-AlxGa1−xN (x = 0.17, 0.28, 0.5), and n-type silicon (Si) doped α-GaN layers were grown by metal-organic vapor phase epitaxy (MOVPE) on c-plane sapphire (α-Al2O3). The four-parameter semi-quantum (FPSQ) dielectric lattice-dispersion model and the Drude model for free-carrier response are employed for analysis of the IR-SE data. Model calculations for the ordinary (∈⊥) and extraordinary (∈||) dielectric functions of the heterostructure components provide sensitivity to IR-active phonon frequencies and free-carrier parameters. We observe that the α-AlxGa1−xN layers are unintentionally doped with a back ground free-carrier concentration of 1–4 1018cm−3. The ternary compounds reveal a two-mode behavior in ∈⊥, whereas a one-mode behavior is sufficient to explain the optical response for ∈||. We further provide a precise set of model parameters for calculation of the sapphire infrared dielectric functions which are prerequisites for analysis of infrared spectra of III-nitride heterostructures grown on α-Al2O3.


2005 ◽  
Vol 892 ◽  
Author(s):  
Mustafa Alevli ◽  
Goksel Durkaya ◽  
Vincent Woods ◽  
Ute Habeck ◽  
Hun Kang ◽  
...  

AbstractGroup III-nitride compound semiconductors (e.g. AlN-GaN-InN) have generated considerable interest for use in advanced optoelectronic device structures. The fabrication of multi-tandem solar cells, high-speed optoelectronics and solid state lasers operating at higher energy wavelengths will be made possible using (Ga1-y-xAlyInx)N heterostructures due to their robustness against radiation and the wide spectral application range. To date, the growth of indium rich (In1-xGax)N films and heterostructures remains a challenge, primarily due to the large thermal decomposition pressures in indium rich group III-nitride alloys at the optimum growth temperatures. In order to control the partial pressures during the growth process of InN and related alloys, a unique high-pressure chemical vapor deposition (HPCVD) system with integrated real-time optical monitoring capabilities has been developed. We report initial results on InN layers grown at temperatures as high as ∼850°C with reactor pressures around 15 bar. Such process conditions are a major step towards the fabrication of indium rich group III-nitride heterostructures that are embedded in wide band gap group III-nitrides. Real-time optical characterization techniques are applied in order to study the gas phase kinetics and surface chemistry processes during the growth process.For an ammonia to TMI precursor flow ratio below 500, multiple phases with sharp XRD features are observed. Structural analysis perform by Raman scattering techniques indicates that the E2 high mode improves as NH3:TMI ratio is decreased to below 500. Optical characterization of these InN layers indicates that the absorption edge shifts from down from 1.85 eV to 0.7 eV. This shift seems to be caused by a series of localized absorption centers that appear as the indium to nitrogen stoichiometry varies. This contribution will correlate the process parameters to results obtained by XRD, Raman spectroscopy and optical spectroscopy, in order to assess the InN film properties.


2004 ◽  
Vol 829 ◽  
Author(s):  
K. Stewart ◽  
S. Barik ◽  
M. Buda ◽  
H. H. Tan ◽  
C. Jagadish

ABSTRACTIn this paper we discuss the growth of self-assembled InAs quantum dots (QDs) on both GaAs and InP substrates by low pressure Metal Organic Chemical Vapor Deposition. The influence of various growth parameters, such as the deposition time, the QD overlayer growth temperature, the V/III ratio and the group III and/or group V interdiffusion on QD formation are discussed and compared for the two systems. Stacking issues and preliminary results for an InAs/GaAs QD laser are also presented.


1996 ◽  
Vol 449 ◽  
Author(s):  
Guohua Qiu ◽  
Fen Chen ◽  
J. O. Olowolafe ◽  
C. P. Swann ◽  
K. M. Unruh ◽  
...  

ABSTRACTThe interfaces between metals and semiconductors are very crucial to the performance and reliability of solid-state devices. At the moment information on the interfaces between metals and group III-nitride semiconductors are very rare. In this study, linear I-V characteristics of titanium and aluminum to A1xIn1-xN of three different composition (x=0.18, 0.50,0.85) were obtained exhibiting ohmic characteristics. Specific contact resistance of these metals to A1.18In.82N and Al.5In.5N was measured by transmission line measurement. Interdiffusion between the metals and the semiconductors, induced by annealing in N2 ambient, was determined using RBS and thermal stability was evaluated.


Sign in / Sign up

Export Citation Format

Share Document